Gravity: Analog pH Sensor Meter Kit For Arduino - The Pi Hut
eter or energy meter is a device that measures the amount of and also have direct pulse output connection that compatible to the Arduino. To make sure the pulse taken accurately, the output pulse from LED blinking is more suitable. This meter water to measure moisture content.
GSM-Based Smart Energy Meter with Arduino Uno
So we will use the S pin as analog input connecting Arduino, the value read will be higher depending on the sensor surface is covered with water. This is because the water acts as a conductor, given that the water we use in our deposits not be pure water (H2O), since if water is nonconductive.
Simple Arduino Home Energy Meter - The DIY Life
2/1/2017This simple but useful project based on arduino nano. It is a cheap and intelligent way to control your water tank levels. Also it can be used for your school and college project. Like this
DIY Arduino Wind Speed Meter Anemometer Project - Geeky
The project reads and displays the height of water level in a well or a cistern. We will use Arduino, an ultrasonic sensor, a 16 x 2 LCD display and a buzzer. Home Water Tank level display with Arduino. Water Tank level display with Arduino. By Boris Landoni on August 28, 2011 Using a Flow Meter . My Project
Phase Smart Energy Meter using Arduino - Engineer
Arduino based Digital Water Flow Meter using YF-S201 Hall Effect Sensor(DIY) Water Flow Meter is an automatic system for measurement of water flow. This project is using Arduino microcontroller with Hall's effect based water flow sensor (YF-S201) and LCD is to display output.
Simple Digital Water Flow Meter Circuit using Arduino
1/21/2010 Reading Water Flow Rate from a flow @ Jonathan Oxer I actually got the idea for my whole project from that one project in practical arduino. I searched for months for a cheap flow sensor that was small enough to fit in a PC case.
Reading Water Flow Rate from a flow meter - Arduino Forum
The Arduino based wireless power meter is a non-invasive current meter for household power with a Matlab interface. Current is measured using split core current transformers. This data is then transmitted over a 802. 11b connection through the home [s wireless router to the base station and Matlab interface.
Arduino pH and ORP/chlorine data logger – Maximilian Hofer
Working with Water Flow Sensors Arduino. with the help of readily-available and low-cost water flow sensors. YF-S201 Hall-Effect Water Flow Sensor. We are very much interested in producing this meter. We shall continue to be in touch. Regards. B S Murty. Posted on August 14th 2015 | 11:59 am.